Rear Panel - Test Fit

Rear Panel - Test Fit

With the test fit of the front panel complete, the same should be done with the back panel.

The process is the same as the front. Print, remove support material, tap holes. All of the holes on the back are #10-24 with the exception of the hole centered on the bump. This one is 1/4-20, which is the standard size for a tripod mount.

With the plastic prepped, put in the jacks. The video jacks go in from the outside and you tighten the nut on the inside. Although they're not pictured here, the power jacks are the opposite.

Now would be a good time to make sure the rear panel fits into the front.

With the test fits of both panels now complete, let's take it all apart again and get started on the wiring.

 

Copyright Notice

NEFPV is a registered not-for-profit corporation. All content is copyright NEFPV, Inc and not to be used without permission.

But seriously, just email us. We're very friendly hobbyists who want to help you out.

 

Recent comments

Zircon - This is a contributing Drupal Theme
Design by WeebPal.