Dronekraft Mach300GT Build -Part II

Dronekraft Mach300GT Build -Part II

Got the ESCs wired up yesterday. Because of the way the they need to sit on the frame, I resoldered the power leads to run in the same direction as the motor leads.

I'm not liking the way the bullet connectors are laid out on the board. The rubber bobbins are right where the wires from the ESC want to be. And I couldnt plugin the bullet connectors without removing the bobbins first. I was ready to just unsolder the bullets and just solder the ESCs to the boards, but in the end decided to go with how the frame was designed. I can always change my mind later.

Motors are next...

 

Copyright Notice

NEFPV is a registered not-for-profit corporation. All content is copyright NEFPV, Inc and not to be used without permission.

But seriously, just email us. We're very friendly hobbyists who want to help you out.

 

Recent comments

Zircon - This is a contributing Drupal Theme
Design by WeebPal.